fiber bragg grating for temperature sensing Electrical fire monitoring system-INNO

The electrical fire monitoring system, automatic fire alarm system, and leakage fire alarm system, although to some extent filling the gap of rapid response and fire prevention in the event of a fire, cannot solve the problem of excessive contact resistance and heating at the internal connection points of the switchgear due to oxidation, frouxidão, and pollution during operation, especially the problem of high temperature rise at the connection points between the feeder cable and the busbar or switch due to overload, thus burying fire hazards.

The Design Specification for Fire Automatic Alarm System states that the temperature measurement system should mainly be installed in key heating parts such as cable joints, e a medição da temperatura de contato deve ser usada para linhas abaixo de 1kV, e a medição da temperatura da rede de fibra óptica deve ser usada para linhas acima de 1kV. Na verdade, sistemas de medição de temperatura de grade de fibra óptica podem atender aos requisitos de medição de temperatura de contato, e também pode ser aplicado em ambientes de alta tensão com excelente desempenho de isolamento.

Os projetistas estão mais preocupados com a temperatura dos pontos de conexão internos do quadro, e esperamos poder obter informações de temperatura em tempo real para lidar prontamente com falhas. No entanto, métodos convencionais de medição de temperatura usam principalmente sensores de temperatura, dispositivos de imagem infravermelha, e cabos de detecção de temperatura, que não pode satisfazer plenamente este requisito, refletido principalmente nos seguintes aspectos:

1) Métodos convencionais de medição de temperatura, como termopares, termistores, and semiconductor temperature sensors are not recommended for use inside high and low voltage cabinets due to their inherent electrification or the need for metal wires to transmit signals, and their insulation cannot be guaranteed.

2) The handheld infrared thermal imager must maintain a distance from the object being tested, which is a non-contact temperature measurement method that requires manual operation and cannot achieve uninterrupted online measurement. Além disso, the temperature data measured is the thermal radiation value of the object surface, which is easily affected by the environment and has poor authenticity.

High and low voltage switchgear are all “selado” tipo, and when the equipment is in operation, the small room is usually closed. Além disso, there are many live conductors inside the cabinet, making manual inspection very difficult.

Temperature sensing cable temperature measurement is a linear temperature measurement method that cannot locate the temperature or temperature changes at a certain point, and therefore cannot be applied to temperature measurement at switch cabinet connection points.

The characteristics and advantages of sistemas de medição de temperatura de grades de fibra óptica

Como é bem conhecido, when the system or equipment is overloaded, the circuit breaker needs to accumulate heat before it can act, which is a long process. When the circuit breaker refuses to act or fails to act, it can cause harm to equipment such as busbars, interruptores, and cabinets, and even lead to a fire. O sistema de medição de temperatura de grade de fibra óptica can meet the requirements of contact temperature measurement and can measure the temperature of the monitored object in real time without power outage. It can indirectly monitor the operation of equipment or distribution circuits, allowing management personnel to know abnormal temperature information in the first time, eliminate fire hazards in the first time, and improve automation and response speed.

Introduction to the working principle of fiber optic grating temperature sensor para medição de temperatura

The fiber optic grating temperature measurement system uses fiber optic as the transmission medium, utilizing the temperature sensitivity of Bragg gratings and the principle of light reflection, to detect real-time temperature changes in the heating parts of power facilities in the power system, and perform multi-point temperature data collection, cálculo, mostrar, diagnóstico, e alarme.